● 異常狀況：
當您確認所有設定都正確，但是在LMTools的Server Status頁籤下執行檢查卻出現錯誤訊息「FLEXnet Licensing error:-1,359. System Error: 2 "No such file or directory"」。
● 解決方式：
1. 參考如何更新Autodesk Network License Manager的版本？，更新或重新安裝Autodesk Network License Manager。
2. 參考安裝說明，確認所有設定都正確。
3. 執行LMTools，在【Service/License File】頁籤下，勾選【LMTOOLS ignores license file path environment variables】。
4. 在LMTools的【Start/Stop/Reread】頁籤下，先按【Stop Server】再按【Start Server】重新啟動授權服務即可。
http://www.synnex.com.tw/asp/fae_qaDeta ... eqno=21718
系統管理員
文章: 14203
註冊時間: 2026年 4月 30日, 11:43
系統管理員
文章: 14203
註冊時間: 2026年 4月 30日, 11:43
關於該問題官方更新資料如下
問題：
You are trying to start your license server but it will not launch and if you check the Server Status, you will see:
The license files (or license server system network addresses) attempted are
listed below. Use LM_LICENSE_FILE to use a different license file,
or contact your software provider for a license file.
Filename:
License path:
FlexNet Licensing error:-1,359. System Error: 2 "No such file or directory"
Causes:
解決方案：
● 檢查並確認授權文件與目錄設定無誤 Make sure the license file path in the Config services tab is correct.
● 確認勾選 "LMTOOLS ignore license file path environment variables",並重啟服務 and then try to restart the service.
● 暫停特定防毒軟體後重啟服務，目前有紀錄"Sophos Endpoint Security" 可能導致出現 -1,359 錯誤.
資料來源
https://knowledge.autodesk.com/support/ ... l?st=error
問題：
You are trying to start your license server but it will not launch and if you check the Server Status, you will see:
The license files (or license server system network addresses) attempted are
listed below. Use LM_LICENSE_FILE to use a different license file,
or contact your software provider for a license file.
Filename:
License path:
FlexNet Licensing error:-1,359. System Error: 2 "No such file or directory"
Causes:
解決方案：
● 檢查並確認授權文件與目錄設定無誤 Make sure the license file path in the Config services tab is correct.
● 確認勾選 "LMTOOLS ignore license file path environment variables",並重啟服務 and then try to restart the service.
● 暫停特定防毒軟體後重啟服務，目前有紀錄"Sophos Endpoint Security" 可能導致出現 -1,359 錯誤.
資料來源
https://knowledge.autodesk.com/support/ ... l?st=error