原文網址A
http://upandready.typepad.com/up_and_ready/2011/09/autocad-family-jit-just-in-time-debugging-errors.html原文網址B
http://upandready.typepad.com/up_and_ready/2012/06/ammgdinteropdll-errors-when-starting-up-autocad-mechanical-2013.htmlA：AutoCAD Family: JIT (just-in-time) debugging errorsI have had a handful of cases in the last year dealing with JIT (just-in-time) debugging errors. Typically, it has happened on Windows XP.
These errors typically indicate that the video card is not powerful enough to run the product. The Certified Hardware list is located here:
http://usa.autodesk.com/adsk/servlet/cert?siteID=123112&id=16391880 In one of my scenarios, we had two identical systems using an unsupported Intel Intergrated Graphics/Video card. One of the systems was able to run AutoCAD 2012 but the other system had a JIT (just-in-time) error. The issue was resolved by updating the video driver from the vendor. In this case, both computers are now running the same video driver.
B：AmMgdInterop.dll errors when starting up AutoCAD Mechanical 2013We have received several reports regarding AmMgdInterop.dll error messages when starting AutoCAD Mechanical 2013, while starting AutoCAD Mechanical 2013 with AutoCAD profile works fine. The development team is currently investigating the issue.
A procedure imported by ‘AmMgdInterop.dll’ could not be loaded.
At this time this issue mainly occurs on XP 32-bit and Windows 7 32-bit systems and contributing factors are having AutoCAD Mechanical 2013 installed ‘side by side’ with Mechanical Desktop 6, AutoCAD 2002 and AutoCAD R 14. If you happen to have Mechanical Desktop 6, AutoCAD 2002 and AutoCAD R 14, you need to uninstall them to make AutoCAD Mechanical 2013 work as expected.
In some instances reinstalling all Autodesk Products as per following Technical Solution helped as well.
http://usa.autodesk.com/getdoc/id=TS45252
----------------
===========
協勤資訊有限公司
